Chinese中文

Wafer

Interpolator iCs
Interpolator iCs
Interpolator

The Interpolator iCs are fast analog-to-digital converters especially made for the conversion of sine/cosine sensor signals.

The phase angle is retrieved using flash, vector tracking, or sample&hold SAR conversion principles. Incremental output signals are supplied as A/B/Z encoder quadrature signals; BiSS, SSI or SPI interfaces are used when absolute position data is available.

Applications:

iC-Haus Interpolator iCs:

show iC-MG 8-Bit Sin/Cos Interpolation iC with RS422 Driver
show iC-MN 3-Channel, Simultaneous Sampling 13-Bit Sin/Cos Interpolation IC with Nonius Calculation
show iC-MNF 26-bit Nonius Encoder with 3-Ch. Sampling 14-bit Sin/D Interpolation
show iC-MQ Programmable 9-Bit Sin/Cos Interpolation IC with Fail-Safe RS422 Line Driver
show iC-MQF Programmable 12-Bit Sin/Cos Interpolation iC with RS422 Driver
show iC-MR 13-Bit S&H Sin/Cos Interpolator with Controller Interfaces
show iC-MR3 13-Bit S&H Sin/Cos Interpolator with 2.5 V / 5 V Controller Interfaces - (preliminary)
show iC-NG 8-Bit Sine-to-Digital Converter Processor with Waveform Adaptation
show iC-NQ 13-Bit Signal Conditioning Interpolator with BiSS B Interface
show iC-NQC 13-Bit Signal Conditioning Interpolator with BiSS-C Interface
show iC-NQI 13-bit Signal Conditioning Interpolator with 2-Wire Interface
show iC-NQL 13-Bit Signal Conditioning Interpolator with SSI Interface
show iC-NV 6-Bit Sin/Cos Flash Converter with Pin-Selectable Interpolation (to x16)
show iC-NVH 6-Bit Sin/Cos Flash Converter with Pin-Selectable Interpolation (to x16)
show iC-PI Programmable 12-Bit Sin/Cos Interpolation iC with RS422 Driver - (new)
show iC-TW2 Programmable 8-Bit Sin/Cos Interpolation IC with EEPROM
show iC-TW28 10-Bit Sin/Cos Interpolator with Auto-Calibration - (new)
show iC-TW4 8-Bit Sin/Cos Interpolator with Automatic Offset Correction
show iC-TW8 16-Bit Sin/Cos Interpolator with Automatic Calibration

Return to encoder products page